Cucumber Installation Instructions

Contents:

  • Shell
  • 4 rail inserts 
  • 1 bottom insert
  • 9 screws (only need 8)
  • 1 Allen Wrench 
  • Application card with video link
  • Wilson Overgrip 

Steps:

  1. Make sure rail inserts and bottom insert are inside the shell. This should already be the case when shipped. 
  2. Prepare your regular grip to be inserted. If you have an extra overgrip on you may have to remove so the grip can slip into the shell.
  3. Slide the pickleball grip into the shell. 
  4. Make sure the pickleball paddle is centered inside the cucumber grip. Start applying the screws from top to bottom. Make sure you only partially screw in at first while checking the alignment of the paddle.
  5. After the top, complete the bottom. 
  6. Tighten the screws so the paddle is securely in place. DO NOT OVERTIGHTEN as this could ruin the threads on the Cucumber grip. Tighten enough so the paddle is not loose. 
  7. Apply the overgrip. Since the Cucumber grip is much thicker than a regular grip you need to be careful on how much you overlap. There should be limited material left over from the warp.